Instruction For Programming Keyless Remote Rapidshare Need Programming Instructions Keyless Remote Buick Century 2002?

Need programming instructions Keyless remote buick century 2002? - instruction for programming keyless remote rapidshare

IMPORTANT: Before entering programming mode, to take possession of all remote controls that you use on the vehicle. Once the program remotes, all previous codes are erased from memory. Other remote commands will not work until the remote program.

1. Close the vehicle door.

2. Insert the key in the ignition and turn (as far as possible without starter)

3. Turn on the ignition and remove the ignition key.

4. Hold the lock switch on the driver's side door UNLOCK position.

5. Insert the key in the ignition lock cylinder and remove the key. (Do not turn the ignition key in the lock cylinder.)

6. Insert the key in the ignition lock cylinder and remove the key. (Does not apply, turn the ignition key in the lock cylinder.)

7. Insert the key in the ignition lock cylinder. (Do not turn the ignition key in the lock cylinder.) Leave the keys in the ignition cylinder.

8. Relfacilitate the transition of locking the door. The vehicle has three beeps will sound check in the programming mode enabled.

9. Wait press lock and unlock all buttons of the joystick keyless access and, until it sounds twice as many vehicles to check whether the channel has been successfully programmed (this corresponds to approximately 15 seconds lasts).

10. Perform the previous step, up to four channels (), including the elderly.

11. The Delete key to exit the program.

Mike This is the programming information on the key chains for 2002 Buick century.Best chance. If you want to verify this information, please visit the Web site published. http://programyourremote.com/